• Our Customer Care Centre will be closed earlier at 12pm, on 24 December 2024. Usual operating hours will resume on 26 December 2024. We apologise for any inconvenience caused.

    Setting IP v. 6

    20-Feb-2018
    8203954700

    Solution

      The IPv6 addresses of the machine can be configured via the Remote UI. Before setting IPv6 addresses, check the IPv4 address settings. You need to set the correct IPv4 settings to use IPv6 addresses. The machine can use the following multiple IPv6 addresses:

      TypeDescription
      Link-local addressAn address that is only valid within a subnet or link and cannot be used to communicate with devices beyond a router. A link-local address is automatically set when the IPv6 function of the machine is enabled.
      Manual addressAn address that is entered manually. When using this address, specify the prefix length and default router address.
      Stateless addressAn address that is generated automatically using the MAC address of the machine and the network prefix that is advertised by the router. Stateless addresses are discarded when the machine is restarted (or turned ON).
      Stateful addressAn address obtained from a DHCP server using DHCPv6.

      1. Start the Remote UI and log in to System Manager Mode.

      2. Click [Settings/Registration] on the Portal page.

      3. Select [Network Settings] [TCP/IP Settings].

      4. Click [Edit] in [IPv6 Settings].

      5. Select the [Use IPv6] check box and configure the required settings.
      [Use IPv6]
      • Select the check box to enable IPv6 on the machine. When not using IPv6, clear the check box.
      [Use Stateless Address]
      • Select the check box when using a stateless address. When not using a stateless address, clear the check box.
      [Use Manual Address]
      • When you want to manually enter an IPv6 address, select the check box and enter the IP address, prefix length, and default router address in the corresponding text boxes.
      [IP Address]
      • Enter an IPv6 address. Addresses that start with "ff" (or multicast address) and the loopback address (::1) cannot be entered.
      [Prefix Length]
      • Enter a number that indicates how many bits are available for the network address.
      [Default Router Address]
      • Specify the IPv6 address of the default router as necessary. Addresses that start with "ff" (or multicast address) and the loopback address (::1) cannot be entered.
      [Use DHCPv6]
      • Select the check box when using a stateful address. When not using DHCPv6, clear the check box.

      6. Click [OK].
      NOTE
      Checking whether the settings are correct
      • Make sure that the Remote UI screen can be displayed with your computer by using the IPv6 address of the machine.
      Selecting settings from the operation panel
      • IPv6 settings can also be accessed from <Menu> in the Home screen.
      When you have changed the IP address after installing the printer driver
      • You need to add a new port.