Storing the zoom or focal position (PowerShot G3 X)
30-Apr-2015
8202622800
Solution
Zoom positions set with the zoom lever or focal positions set manually are normally reset once you turn the camera off, but they can also be stored on the camera.
The procedure for storing zoom positions in the camera is explained below.
NOTE
- The following section explains the setting procedures when the camera’s shooting mode has been set to [Program AE] (
). - To store the zoom or focal position, it is necessary to set the [Shooting Mode] to one of the following modes.
- [Manual] (
), [Aperture Priority AE] (
), [Shutter Speed Priority AE] (
), [Program AE] ()
), [Aperture Priority AE] (), [Shutter Speed Priority AE] (), [Program AE] ()1. Press the power button to turn the camera on.
2. Press the [MENU] button.
3. Move the zoom lever to choose the [ 
] tab.
] tab.Press the [ 
], [ 
] buttons to choose [ 
].
], [ ] buttons to choose [ ].Press the [ 
], [ 
] buttons to choose [Recall Zoom/MF Settings], and then press the [ 
] button.
], [ ] buttons to choose [Recall Zoom/MF Settings], and then press the [ ] button.
4. Choose [Zoom Memory], press the [ ] button, choose [On], and then press the [ ] button.
] button, choose [On], and then press the [ ] button.
CAUTION
- The zoom position set in [
] auto mode cannot be stored.
1. Complete steps 1 - 3 of Storing the Zoom Position
above.
above.
2. Choose [MF Memory], press the [ ] button, choose [On], and then press the [ ] button.
] button, choose [On], and then press the [ ] button.
This concludes the procedure for storing the zoom or focal position