Techniques for shooting with the zoom (on the telephoto end) (PowerShot N100)
17-Mar-2014
8202065200
Solution
If you cannot shoot the subject up close with the optical zoom, please consider the following.
When distant subjects are too far away to enlarge using the optical zoom, use digital zoom for up to about 20x enlargement.
1. Press the <MENU> button, choose [Digital Zoom] on the [Shooting] tab (
), and then set the [Digital Zoom] to [Standard].
), and then set the [Digital Zoom] to [Standard].Press the <Menu> button to return to the shooting screen.
2. Move the zoom lever toward <
>.
>.- Zooming stops at the largest possible zoom factor (before the image becomes noticeably grainy), which is then indicated on the screen
3. Move the zoom lever toward <> again.
> again.- The camera zooms in even closer on the subject.
IMPORTANT
- Moving the zoom lever will display the zoom bar (which indicates the zoom position). The color of the zoom bar will change depending on the zoom range.
--White range: optical zoom range where the image will not appear grainy.
--Yellow range: digital zoom range where the image is not noticeably grainy (ZoomPlus).
--Blue range: digital zoom range where the image will appear grainy.
Because the blue range will not be available at some resolution settings, you can zoom to the largest possible zoom factor
- The [Digital Zoom] cannot be used in the following modes:
- 
, 
, 
, 
, 
, 
, 
, 
, 
, 
, , , , , , , , ,
NOTE
- Focal length when optical and digital zoom are combined is as follows (35mm film equivalent).
-24 – 480 mm
- To deactivate digital zoom, press the <MENU> button, choose [Digital Zoom] on the [Shooting] tab (), and then choose [Off].
Depending on how you have set the number of recording pixels and the magnification of the [Digital zoom], the [Zoom bar] may be displayed in yellow (ZoomPlus).
To shoot with the [Digital zoom] without causing the image quality to degrade, please shoot within the range of the ZoomPlus.
With the [Digital Tele-Converter] setting, the focal length of the lens can be increased by approximately 1.5x or 2.0x. This can reduce camera shake because the shutter speed is faster than it would be if you zoomed (including using digital zoom) in to the same zoom factor.
1. Press the <MENU> button, and from the [Shooting] tab () set the [Digital Zoom] to either [1.5x] or [2.0x].
) set the [Digital Zoom] to either [1.5x] or [2.0x].
IMPORTANT
- The Digital Tele-Converter cannot be used with digital zoom or AF-point zoom.
- [1.5x] and [2.0x] can only be set in
mode.
NOTE
- The respective focal lengths when using [1.5x] and [2.0x] are 36 – 720 mm and 48 – 960 mm (35mm film equivalent).
- The shutter speed may be equivalent when you move the zoom lever all the way toward <
> for maximum telephoto, and when you zoom in to enlarge the subject to the same size using [Digital Zoom].