Specifying a portion of an image to save separately (Cropping) (PowerShot N100)

    17-Mar-2014
    8202064400

    Solution

      The procedure for specifying a portion of an image to save as a separate image file is explained below.
      IMPORTANT
      • Editing is not possible for images shot at a resolution of [ ], or resized to [ ].

      1. Press the <> button to enter Playback mode.

      2. Press the <MENU> button, and then choose [Cropping] on the [ ] tab.




      3. Press the <><> buttons to choose an image, and then press the <FUNC./SET> () button.






      4. Adjust the cropping area.
      A frame is displayed around the portion of the image to be cropped.



      The original image is shown in the upper left, and a preview of the image as cropped is shown in the lower right.
      • To resize the frame, move the zoom lever.
      • To move the frame, press the <><><><> buttons.
      • To change the frame orientation, press the <FUNC./SET> () button.



      5. Press the <MENU> button.

      6. Press the <><> buttons to choose [OK], and then press the <FUNC./SET> () button.
      The image is now saved as a new file.



      7. Press the <MENU> button. [Display new image?] is displayed.
      Press the <><> buttons to choose [Yes], and then press the <FUNC./SET> () button.



      The saved image is now displayed.
      NOTE
      • Images supported for cropping will have the same aspect ratio after cropping.
      • Cropped images will have a smaller resolution than uncropped images.
      • If you crop still images shot using Face ID, only the names of the people left in the cropped image will remain.

      This completes the steps for specifying a portion of an image to save as a separate image file.