Solution
When setting [Flash] to [Auto], [Flash] is not activated if the surroundings are light. However, when shooting with the subject backlit, [Flash] is sometimes used not to make the subject dark. This section describes the setting to shoot with constant flash.
IMPORTANT
- The following explanations are provided based on the assumption that the [Shooting Mode] is set to [Program AE] (
).
1. Press the <Power> button to turn the camera on.
Move the <Flash> (
) switch to raise the flash.
2. Press the <Flash> (
) button.
3. Press the [
], [
] buttons to select [On] (
).
4. If the following icon is displayed on the monitor, the setting is complete.
IMPORTANT
- The setting screen cannot be accessed by pressing the <Flash> () button　when the flash is lowered. Move the <Flash> () switch to raise the flash,　then configure the setting.
- <Flash> cannot be set to [On] in the following modes:
[Hybrid Auto] (
), [Creative Shot] (
), [Auto] (
), [High-Speed burst] (
), [Low Light] (
), [Fireworks] (
)
