Cleaning the Paper Feed Roller
29-Jul-2011
8201139800
Solution
If the paper feed roller is dirty or paper powder is attached to it, paper may not be fed properly.
In this case, clean the paper feed roller. Cleaning will wear out the paper feed roller, so perform this only when necessary.
You need to prepare: three sheets of A4 or Letter-sized plain paper
1. Make sure that the power is turned on.
2. Open the paper output tray gently, and open the output tray extension.
IMPORTANT
- If the inner cover is open, close it.
3. Select Roller cleaning.
(1) Select 
Setup on the HOME screen.
Setup on the HOME screen.The setup menu screen will appear.
(2) Select 
Maintenance, then touch the OK button.
Maintenance, then touch the OK button.The Maintenance screen will appear.
(3) Select Roller cleaning, then touch the OK button.
The confirmation screen will appear.
(4) Select Yes, then touch the OK button.
(5) Select the paper source to clean (Rear tray or Cassette), then touch the OK button.
4. Clean the paper feed roller without paper.
(1) Follow the message to remove any paper from the paper source you selected in (5) of step 3.
(2) Touch the OK button.
The paper feed roller will rotate as it is cleaned.
5. Clean the paper feed roller with paper.
(1) Make sure that the paper feed roller has stopped rotating, then follow the message to load three or more sheets of A4 or Letter-sized plain paper in the paper source you selected in (5) of step 3.
(2) Touch the OK button.
The machine starts cleaning. The cleaning will be complete when the paper is ejected.
(3) When the completion message appears, touch the OK button.
The screen will return to the Maintenance screen.
REFERENCE
- Touch the HOME button to exit Setup and display the HOME screen.
If the problem is not resolved after cleaning the paper feed roller, contact the service center.
(The photo is the MP560.)
1. Make sure that the power is turned on.
2. Open the Paper Output Tray gently, and open the Output Tray Extension.
IMPORTANT
- If the Inner Cover is open, close it.
3. Select Roller cleaning.
(1) Select Setup on the HOME screen.
Setup on the HOME screen.The setup menu screen will appear.
(2) Select Maintenance, then touch the OK button.
Maintenance, then touch the OK button.The Maintenance screen will appear.
(3) Select Roller cleaning, then touch the OK button.
The confirmation screen will appear.
(4) Select Yes, and touch the OK button.
(5) Open the Rear Tray.
(6) Place a moistened cotton swab, etc. to one of the protrusions (A) of the feed roller shaft.
(7) Select the paper source to clean (Rear tray), and touch the OK button.
Paper feed roller cleaning starts and the shaft will rotate. While the shaft is rotating, clean the protrusions (A) by keeping the swab touching to them one by one.
(8) Repeat steps 6 and 7 for each protrusion (A) of the feed roller shaft until you clean all of them.