• Our Customer Care Centre will be closed earlier at 12pm, on 24 December 2024. Usual operating hours will resume on 26 December 2024. We apologise for any inconvenience caused.

    Compatible Remote Switch (EOS 5D Mark II)

    12-Nov-2008
    8200355600

    Solution

    Remote Switch and Remote Controller
    You can connect the Remote Switch RS-80N3 or Timer Remote Controller TC-80N3 (both sold separately) or any EOS accessory equipped with an N3-type terminal to the camera and shoot with it.


    NOTE
    To operate the accessory, refer to its instruction manual.

    Connecting the Remote Switch
    1. Open the terminal cover.

    2. Connect the plug to the remote control terminal.


    REFERENCE
    To disconnect the plug, grasp the plug's silver part and pull out.

    Remote Control Shooting
    With Remote Controller RC-1 or RC-5 (both sold separately), you can shoot remotely up to about 5 meters/16.4 feet from the camera. RC-1 enables you to shoot immediately or have a 2-sec. delay, and RC-5 has a 2-sec. delay.

    1. Set the power switch to <ON>.

    2. Focus the subject.

    3. Set the lens focus mode switch to <MF>. You can also shoot with <AF>.



    4. Press the <AF・DRIVE> button. Select the self-timer. Look at the LCD panel and turn the
    <Quick Control Dial> to select <>(10-sec. delay) or <>(2-sec. delay).



    5. Point the remote controller toward the camera's remote control sensor and press the transmit button. The self-timer lamp lights and the picture is taken.


    CAUTION
    Camera misoperation may occur near certain types of fluorescent lights. During wireless remote control, try to keep the camera away from fluorescent light.