Setting RX Reports to Print Automatically (MF4380dn/MF4370dn/MF4350d/MF4340d Only)
Solution
This section describes how to set RX reports to print automatically.
The default setting is <OUTPUT NO>.
The following items are printed in an RX Report:
- JOB NO.: Job number
- MODE: Mode of transaction (G3 or ECM)
- NO.: Sequence number
- DESTINATION TEL/ID: Number of the sending machine (displayed only if registered in their machine)
- START TIME: Date and time of transaction
- PAGE: Number of pages received
- RESULT: Result of transaction
- OK: Reception successful
- NG: Reception failed
- STOP: Reception manually canceled before completion
- MEM.FULL: Memory became full during reception.
1. Press 
[Menu].
[Menu].2. Press [ 
] or [ 
] to select <REPORT SETTINGS>, then press [OK].
] or [ ] to select <REPORT SETTINGS>, then press [OK].3. Press [ ] or [ ] to select <RX REPORT>, then press [OK].
] or [ ] to select <RX REPORT>, then press [OK].4. Press [ ] or [ ] to select the setting you want, then press [OK].
] or [ ] to select the setting you want, then press [OK].- <OUTPUT NO>: Does not print a report.
- <OUTPUT YES>: Prints a report every time you receive a document.
- <PRINT ERROR ONLY>: Prints a report only when a reception error occurs.
5. Press 
[Stop/Reset] to return to the standby mode.
[Stop/Reset] to return to the standby mode.