• Our Customer Care Centre will be closed earlier at 12pm, on 24 December 2024. Usual operating hours will resume on 26 December 2024. We apologise for any inconvenience caused.

    Writing Error/Output Error/Communication Error (Windows)

    11-Jun-2008
    8200217000

    Issue


    Cause and Solution

    Check 1: If the Power lamp is off, make sure that the power plug is plugged in, then turn the printer on
    While the Power lamp is flashing green, the printer is initializing. Wait until the Power lamp stops flashing and remains lit green.

    Check 2: Make sure that the printer port is configured appropriately in the printer driver
    * In the following instructions, "XXX" signifies your printer's name.
    1. Log on as a user account with administrator privilege.
    2. Click Control Panel, then Printer under Hardware and Sound.
    In Windows XP, click Control Panel, Printers and Other Hardware, then Printers and Faxes.
    In Windows 2000, click Control Panel then Printers.
    3. Right-click the Canon XXX icon, then select Properties.
    4. Click the Ports tab to confirm the port settings.
    5. Make sure that a port named USBnnn (where "n" is a number) with Canon XXX appearing in the Printer column is selected for Print to the following port(s).
    If the port setting is not correct, reinstall the printer driver or change the port setting according to the interface you are using.

    Check 3: Make sure that the USB cable is securely plugged in to the printer and the computer
    • If you are using a relay device such as a USB hub, disconnect it, connect the printer directly to the computer, and try printing again. If printing starts normally, there is a problem with the relay device. Consult the reseller of the relay device for details.
    • There could also be a problem with the USB cable. Replace the USB cable and try printing again.

    Check 4: Make sure that the printer driver is installed correctly
    Uninstall the printer driver following the procedure described in Uninstalling the Printer Driver and reinstall it following the procedure described in your setup manual.
    Install the Software
    To use the printer by connecting it to a computer, software including the drivers need to be copied (installed) to the computer's hard disk.
    The screens below are based on Windows Vista operating system Ultimate Edition (hereafter referred to as " Windows Vista ") and Mac OS X v.10.5.x .

    Check 5: Check the status of the device on your computer
    Follow the procedure below to check the status of the device.
    1. Click Control Panel, Hardware and Sound, then Device Manager.
    If the User Account Control screen is displayed, follow the on-screen instructions.
    In Windows XP, click Control Panel, Performance and Maintenance, System, then click Device Manager on the Hardware sheet.
    In Windows 2000, click Control Panel, System, then Device Manager on the Hardware sheet.
    2. Double-click Universal Serial Bus controllers then USB Printing Support.
    If USB Printing Support is not displayed, make sure that the printer is correctly connected to the computer.
    3. Click the General tab and make sure that there is no indication of a problem with the device.
    If a device error is displayed, refer to Windows help to resolve the error.