Using AF+MF (PowerShot G3 X)
Solution
You can fine-tune the focus after autofocusing by turning the continuous ring.
IMPORTANT
- The following section explains the setting procedures when the camera’s shooting mode has been set to [Program AE] (
).
For a list of shooting modes in which AF+MF cannot be set, please refer to the table at the end of the page.
1. Press the power button to turn the camera on.
2. Press the [MENU] button.
3. Move the zoom lever to choose the [ 
] tab.
] tab.Press the [ 
], [ 
] buttons to choose [ 
].
], [ ] buttons to choose [ ].Press the [ 
], [ 
] buttons to choose [AF+MF], and then press the [ 
] button.
], [ ] buttons to choose [AF+MF], and then press the [ ] button.
4. Press the [ ], [ ] buttons to choose [On], and then press the [ ] button.
], [ ] buttons to choose [On], and then press the [ ] button.
5. Press the [MENU] button to return to the previous screen.
6. Press the shutter button halfway to focus on the subject, and continue holding the button halfway down.
7. Turn the [ 
] ring. Referring to the onscreen MF indicator bar (which shows the distance and focal position) and the magnified display area, turn the [ ] ring to adjust the focus.
] ring. Referring to the onscreen MF indicator bar (which shows the distance and focal position) and the magnified display area, turn the [ ] ring to adjust the focus.
NOTE
- To enlarge or reduce the magnified display, press the [DISP.] button.
- To cancel focusing, release the shutter button.
AF+MF cannot be set in the shooting modes shown in the table below.
| Model | Shooting mode |
| PowerShot G3 X |  ,  ,  ,  ,  ,  ,  ,  ,  |