Non-Contact Length Measuring Meter - Set Measure
Installation Note 1: Measurement Direction
Check the SCAN direction on the bottom of the device, and place the device so that the measurement object matches the direction of movement.
Installation Note 2: Measuring Distance
Bottom of the sensor*
Place the measurement object surface at a distance of 70 mm (± 15 mm).
* The outermost part of the body.
1. Attach the measurement distance adjustment tool to the irradiation section.
2. Install it in a position where the light beams become one.
3. The position where the luminous flux becomes one is 70 mm.
* Used when changing parameters and performing measurements and analysis using a PC app.
Connect the USB cable (sold separately) to the USB connector.
Then, connect it to your PC and start the app.
The device starts up by turning on the customer-supplied DC power supply.
When you press the measurement start button in the app, the LED will illuminate, and measurement will begin.
The lighting of the lamp changes depending on the status of the device.
1. When starting the device
When the power is turned on, the POWER lamp and STATUS lamp will light temporarily. After a certain period of time, only the POWER lamp will remain lit.
2. When a warning occurs
When a warning occurs, the STATUS lamp flashes. Please check the warning content using the software.
Once measurement is possible, the STATUS lamp will stop blinking.
If the measurement results are abnormal or the temperature approaches the upper or lower limits of the operating temperature, a warning will be displayed. Measurement will continue even when a warning is displayed, but the measurement result may not be accurate. When recover from abnormal condition, the status bar (top of the app) will automatically return to normal after a certain period of time.
Key Warnings
You can check the warning contents after the measurement is complete if you use the app.*1
If you encounter any of the following warnings, you may be able to avoid them by changing the measurement mode.*2
*1 Warnings will be displayed in a summary after the measurement is complete.
*2 For information on each measurement mode, please refer to "Mode function".
